Aries-automotive 2042 User Manual download pdf

2042 TOYOTA

96-98 4RUNNER/96-99 TACOMA

INSTALLATION

PARTS LIST

1 – Front Aries Bar 6 – 7/16” x 1-1/4” Hex bolts

2 – Frame brackets 6 – 7/16” Hex nuts

12 – 7/16” Flat washers

INSTALLATION OF BOTTOM FRAME BRACKET

Remove tow hooks from front of vehicle.

Using the bolts that held the tow hooks in place (two bolts per hook) attach the mounting

bracket as per the diagram below. Do not fasten bolts too tightly to allow you to adjust the

alignment.

INSTALLATION OF FRONT BAR

Line up the three holes on the lower portion of the front bar with the three holes on the

frame mounting brackets (outer edge). Using the 7/16” Hex bolts, nuts and washers, fasten

the front bar to the mounting brackets, leaving loose for adjustment.

Once the front bar is attached to the mounting brackets, align until satisfied with fit and

balance, and tighten all fasteners.

NOTE: It is advisable to re-check all fasteners for tightness after one week.

FINISH PROTECTION- ARIES PRODUCTS HAVE A HIGH FINISH THAT MUST BE MAINTAINED SUCH AS ANY

OTHER HIGH FINISH PRODUCT ON THE VEHICLE. PROTECT THE FINISH WITH A NON-ABRASIVE AUTOMOTIVE

WAX. THE USE OF SOAP, POLISH, OR WAX THAT CONTAINS ABRASIVES IS DETRIMENTAL, AS THE COMPOUNDS

SCRATCH THE FINISH AND OPEN IT TO CORROSION.

DISCLAIMER- BUYER ASSUMES ALL RISK AND LIABILITY WHATSOEVER FROM THE INSTALLATION AND USE OF

ARIES PRODUCTS. ARIES PRODUCTS ARE SOLD AS DECORATIVE ACCESSORIES AND SHOULD NOT BE RELIED

UPON AS PROTECTION FOR THE VEHICLE OR OCCUPANTS IN THE EVENT OF A COLLISION OR ROLL OVER. ARIES

AUTOMOTIVE ASSUMES NO LIABILITY FOR INJURY, LOSS, INCIDENTAL OR CONSEQUENTIAL DAMAGES IN THE

EVENT OF A COLLISION OR ROLLOVER

Page 1

2042 TOYOTA 96-98 4RUNNER/96-99 TACOMA INSTALLATION PARTS LIST 1 – Front Aries Bar 6 – 7/16” x 1-1/4” Hex bolts 2 – Frame brackets 6

No comments

Aries-automotive 2042 User Manual