Aries-automotive 2052 User Manual download pdf

2003 Toyota Tundra 2/4WD Part # 2052

Installation Instructions

Parts List

1 – front bar 2 – Top brackets

2 – Frame brackets 2 – 3/8 x 1 Button bolts

2 – 3/8 hex nuts 2 – 3/8 Flat Washers

6 – 7/16 x 1 ¼ Hex bolts 6 – 7/16 Hex Nuts

12 – 7/16 Flat Washers

Installing the top brackets

Open the vehicle hood to get to the existing hex nuts (located top left and top right). The bolt pattern on the

top brackets will be positioned in the manner shown in illustration (passenger side shown). Attach top

brackets using the existing factory hex nut. Hand-tighten as you may have to move brackets around.

Installing the frame brackets

Remove factory tow hooks (but do not discard the factory bolts). The bolt pattern on the frame mounting

brackets will be positioned in manner shown in illustration (passenger side shown). Attach frame brackets

using the factory bolts.

Installing the front bar

Line up the three holes on the lower portion of the front bar with the three holes on the frame brackets

(inner edge). Use the 7/16 x 1 ¼ hex bolts, 7/16 hex nuts and 7/16 flat washers to fasten the front bar to the

frame brackets. Top portion of the front bar will line up with the hole on the top brackets (outer edge).

Use the 3/8 x 1 button bolts, 3/8 hex nuts and 3/8 flat washers to fasten the front bar.

Once the front bar is attached to all mounting brackets, align the left and right side of the front bar to the

bumper and tighten all fasteners.

NOTE: It is advisable to re-check all fasteners for tightness after one week.

Attach using the 3/8 x 1 button bolts

(Align to the inner edge of front bar side plate)

Passenger Side Shown

Attach Using the

existing hex nut on

vehicle (under hood)

Use existing hex bolts

on vehicle

Align front bar between

frame brackets

2003 Toyota Tundra 2/4WD Part # 2052 Installation Instructions Parts List 1 – front bar 2 – Top brackets 2 – Frame brackets 2 – 3/8

No comments

Aries-automotive 2052 User Manual