Aries-automotive 25009 User Manual download pdf

PARTS LIST:

Qty Description Qty Description

1 Driver/Left Door 4 8mm Flat Washers

1 Passenger/right Door 2 Rubber Bushing

4 8mm Lock Nuts 2 Philips Head Sheet Metal Screws

PROCEDURE:

REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ

INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION.

NOTE:

2. Starting on the Rear Passenger side of vehicle remove the (2) factory 50mm Torque bolts securing

the doors onto the hinges, as seen below in (Fig 1). Locate the lower kick panel as seen in (Fig 2)

remove the plastic cover with a flat tipped screw driver exposing the dome light wire harness

disconnect wire by pulling the red clip back and unplugging the dome light wire from the harness

as seen in (Fig 3) followed by removing the swing out safety strap, seen in (Fig 4). Once removed

lift off the door and place it off to the side.

3. With the factory door removed select your new passenger/right side tubular door slide the door

pins into the factory hinges & secure the doors with (2) 8mm Flat washers & (2) 8mm Lock Nuts as

seen in (Fig 5) Snug the hardware but do not tighten at this time, before closing the door select the

rubber bushing and attach to the inner tube with the Philips head sheet metal screw where the

inner latch is on the door jam seen in (Fig 6), check the alignment of the locking door latch with the

striker plate inside the door jam of the vehicle seen in (Fig 7) (this may need to be adjusted so that

the door closes completely) if it needs adjustment loosen the toque bolts on the door jam of the

Jeep and align with the door latch on the tubular doors, once in alignment tighten the torque

fasteners check to see that the door completely locks before continuing to the next step.

Page 1 of 3

INSTALLATION INSTRUCTIONS

2007-13 JEEP JK REAR ALUMINUM TUBULAR DOORS

PART# 25009

Passenger/right side

Rear Door

Driver/left side

Rear Door

1 2 3

PARTS LIST: Qty Description Qty Description 1 Driver/Left Door 4 8mm Flat Washers 1 Passenger/right Door 2 Rubber Bushing 4 8mm Lock Nut

Page 2

4. Repeat steps 2 through 3 for Driver/left side installation. 5. Do periodic inspections to the installation to make sure that all hardware is

Passenger side shown Page 3 of 3 Fig 7 Complete installation Secure with (2)8mm Fl

No comments

Aries-automotive 25009 User Manual