Aries-automotive 3049 User Manual

Browse online or download User Manual for For the car Aries-automotive 3049. Aries Automotive 3049 User Manual

  • Download
  • Add to my manuals
  • Print
  • Page
    / 2
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 0
Installation Instructions Front Bar Part # 3049
2001-04 FORD ESCAPE
Parts List
1 – Front bar 2 – 3/8 x 1” Button Bolts
2 – Frame mounting brackets 4 – 3/8 Hex nuts
2 – top mounting brackets 2 – 3/8 flat washers
2 – ½ flat washers 2 – 3/8 x 1” Hex Special Bolts
8 – 7/16 x 1 ¼ Hex bolts 2 – 5/16 x ¾” Hex bolts
8 – 7/16 Hex nuts 2 – 5/16 Hex nuts
18 – 7/16 Flat washers
Installing the frame mounting brackets
1. Remove the bolts securing the two piece plastic guard located underneath the
vehicle in order to install the frame brackets.
2. Once the plastic guard is removed, kit will show three holes, three on each end of
the member frame.
3. Attach passenger side. (as shown on diagram) Place the mounting frame bracket
flat side up against frame. Slide the bracket until it stops against the tie-down
bracket of the vehicle. (note: you will need to cut off a piece of the front
spoiler bumper, underneath the vehicle where the welded tab of the
mounting bracket sits on) Fasten (do not tighten) the angle end of the bracket to
the vehicle tie-down bracket using the 7/16 x 1 ¼ hex bolts, 7/16 flat washers and
½ flat washers.
4. Insert the 3/8 1” special bolt through the hole on the member frame and mounting
frame bracket. Fasten using the 3/8 hex nuts and 3/8 flat washers.
5. With the help of another person, align the front bar to the mounting frame
brackets (inner side of the mounting brackets) and fasten using the 7/16 x 1 ¼”
hex bolts, 7/16 hex nuts and 7/16 flat washers.
Installing the support brackets
6. Once the front bar is in place, proceed to install the support brackets (refer to the
diagram to identify passenger side). Aligning brackets on the inner side of the
vertical plates, attach using the 3/8 x 1” button bolts, 3/8 hex nuts and 3/8
washers.
7. On the other end of the support brackets, you will find a plastic plug that aligns to
the position of the bracket, remove the plastic plug and insert the 5/16 x ¾ hex
bolts and 5/16 hex nuts through the top.
8. Align the front bar to the bumper and proceed to tighten all fasteners.
Page view 0
1 2

Summary of Contents

Page 1

Installation Instructions Front Bar Part # 3049 2001-04 FORD ESCAPE Parts List 1 – Front bar 2 – 3/8 x 1” Button B

Page 2 - Passenger side frame

Passenger side frame mounting bracket Use 3/8 x 1 Special Bolt Use 7/16 x 1 ¼ Hex bolt Use 3/8 x 1” Button bolt Use 5/16 x ¾” Hex Bolt Passeng

Comments to this Manuals

No comments