Aries-automotive 2549 User Manual download pdf

Page 1 of 2 2/5/09 Rev 1(DP)

PARTS LIST:

1 Sport Bar 4 12-1.75mm x 35mm Hex Head Bolts

1 Driver/Left Frame Mounting Bracket 2 12-1.75mm x 40mm Hex Head Bolts

1 Passenger/Right Frame Mounting Bracket 6 12mm Lock Washers

1 Driver/Left Mounting Bracket 10 12mm ID x 30.1mm OD x 3.1mm Flat Washers

1 Passenger/Right Mounting Bracket 4 12mm Hex Nuts

PROCEDURE:

1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS

CAREFULLY BEFORE STARTING INSTALLATION. CUTTING IS REQUIRED. ASSISTANCE IS

RECOMENNDED.

2. Starting under the front of the vehicle, remove the plastic splash guard and place it on a clean,

stable work area. IMPORTANT: Pay close attention to the specific location of all of the two-

piece plastic clips and screws to make reinstallation easier. Use a small flat blade screwdriver

to gently pry up the plastic center pin to release the clips and remove the center pin and the

plastic housing.

3. Locate the (4) factory hex bolts securing the crossmember to the frame. NOTE: Only install

one Frame Mounting Bracket at a time and only remove the (3) factory hex bolts required to

install the Bracket, (Figure 1). Select the driver side Frame Mounting Bracket and bolt it into

position with the factory hex bolts. Snug the hardware but do not tighten at this time.

4. Select the driver side Mounting Bracket. Bolt the Mounting Bracket to the inside of the Frame

Mounting Bracket with the included (2) 12mm x 35mm Hex Bolts, (2) 12mm Lock Washers, (4)

12mm Flat Washers and (2) 12mm Hex Nuts, (Figure 2). Snug but do not tighten hardware at

this time. Repeat Steps 3 & 4 for the passenger side bracket installation.

5. Place the Sport Bar face down on a clean surface in front of the vehicle. NOTE: Use the

packing materials to protect the finish on the Sport Bar. With assistance, carefully position the

Sport Bar up to the Mounting Brackets. Attach the Sport Bar to Mounting Brackets using the

included (2) 12mm x 40mm Hex Bolts, (2) 12mm Lock Washers, (2) 12mm Flat Washers,

(Figure 2).

6. Level and adjust the Sport Bar and tighten all hardware.

INSTALLATION INSTRUCTIONS

SPORT BAR

06-09 TOYOTA RAV4

PART #2549

Driver Side

Mounting

Bracket

Passenger Side

Mounting

Bracket

Driver Side

Mounting

Bracket

Passenger Side

Frame Mounting

Bracket

1 2

INSTALLATION INSTRUCTIONS 1

Summary of Contents

Page 1 - INSTALLATION INSTRUCTIONS

Page 1 of 2 2/5/09 Rev 1(DP) PARTS LIST: 1 Sport Bar 4 12-1.75mm x 35mm Hex Head Bolts 1 Driv

Page 2

Page 2 of 2 2/5/09 Rev 1(DP) 7. Hold the splash guard up into position and mark the location to cut the splash

Comments to this Manuals

No comments

Aries-automotive 2549 User Manual

Browse online or download User Manual for For the car Aries-automotive 2549. Aries Automotive 2549 User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for For the car Aries-automotive 2549