Aries-automotive 4042 User Manual download pdf

INSTALLATION INSTRUCTIONS

4042 CHEVROLET’/GMC

88-98 PICK UP 92-99 SUBURBAN 95-99 TAHOE

95-99 YUKON

PARTS LIST

(1) FRONT ARIES BAR (6) 7/16” X 1 ¼” HEX BOLTS

(2) FRAME BRACKETS (6) 7/16” HEX NUTS

(2) BRACE BRACKETS (12) 7/16” FLAT WASHERS

(4) ¼” X 1 CAP SCREWS (4) ¼” NYLOCK NUTS

INSTALLATION OF BOTTOM FRAME BRACKET

Remove tow hooks from front of vehicle.

Using the bolts that held the tow hooks in place (two bolts per hook) attach the mounting

brackets as per diagram1 below. Don’t fasten too tightly to allow for adjustment.

INSTALLATION OF BRACE BRACKETS

Remove 3 bumper mounting bolts from the front of the frame and the 2 side support

bracket bolts from each side of the vehicle. Lower the bumper so you can see upper

bolts that secure the bumper to the bumper mounting brackets. Position large hole of

top bracket to upper bumper bolt. Replace the bumper to its original position and

position small hole of the brace bracket to the middle plate of the front bar. Adjust

bracket bolts, replace bumper and tighten all bolts.

INSTALLATION OF FRONT BAR

Line up the 3 holes on the lower portion of the front bar with the 3 holes on the frame

mounting brackets (outer edge). Using the 7/16” hex bolts, nuts and washers, fasten the

front bar to the mounting brackets, leaving loose for adjustment.

NOTE

: IT IS ADVISABLE TO RE-CHECK ALL FASTENERS FOR TIGHTNESS

AFTER ONE WEEK.

DIAGRAM 1 DRIVERS SIDE SHOWN

DIAGRAM 2 BRACE BRACKETS

Page 1

INSTALLATION INSTRUCTIONS 4042 CHEVROLET’/GMC 88-98 PICK UP 92-99 SUBURBAN 95-99 TAHOE 95-99 YUKON PARTS LIST (1) FRONT ARIES BAR (6) 7

No comments

Aries-automotive 4042 User Manual